Pop Up Gazebo Instructions

Extend the structure by about 1/3. To do this, grip the scissors in the middle of the roof structure; in the case of rectangular tents, grip the scissors on the short side. Caution: do not pull the gazebo legs and do not open the frame completely.

Place the roof still folded in the centre of the structure. Then open it and unfold half of it, checking that the centre of the canvas matches the centre of the structure.

Raise the central gable of the gazebo structure by pushing it upwards, then cross the elastic loops in the centre of the canvas and fasten them over the slots on the plastic gable hood.

Push the gable downwards, bringing it back to its original position.

Check that the circular fabric reinforcements are exactly at the point of contact between the roof and the structure. Then close the Velcro strips around the upper part of the gazebo leg.

Now the sides of the gazebo must be fixed. Pass the Velcro strips through the plastic connecting elements on the sides of the structure, then bring them upwards and close them.

Open the structure completely by gripping the central scissors, or close it again to use the tent at a later time.

Open the transport bag by unhooking the belt at the base and pulling off the strap, after which, open the Velcro strip and lift the bag upwards.

Extend the frame completely in order to do this hold the central scissors (not the gazebo legs) and spread them outwards and simultaneously pull them backwards.

Hold the tent leg firmly with your foot and push up the corner scissors until the spring-loaded pin clicks in, repeat the same operation in all 4 corners. The roof will rise automatically.

Close the Velcro straps of the roof. To do this, pass the straps, which are at the height of the valance's scissors on the four sides of the roof, under the scissor and close them upwards. Tighten the fasteners securely, so that the valance will always remain tight and no unsightly creases will form.

Lift one leg and press the spring-loaded button on it. Push the tent leg down with your foot until the spring button snaps into the desired position.

The gazebo must always be properly secured to the ground. This can be done using a fastening set consisting of straps and pegs or cast iron stackable weights.

Raise one leg, press the spring button on it and push the upper leg down. Repeat for all 4 legs

Open the roof straps on the four sides and fold the Velcro strips back on themselves. Then lift the corner scissors slightly and press the red button to unlock the frame and repeat at the four corners. Thanks to the smart mechanism, the structure will unlock safely without falling over completely.

Lift the tent slightly by gripping it with the central scissors and close it by pushing inwards. Do not push the legs!

Open the transport bag, place it on the tent and close it by means of the Velcro strap and lower strip. To avoid stains caused by moisture, do not close the roof again unless it is completely dry!